hwmon: (pmbus/core) Add support for rated attributes

Adding implementation for new attributes (rated_min/rated_max) to
cover PMBus specification about rated values reporting:
MFR_VIN_MIN, MFR_VIN_MAX, MFR_IIN_MAX, MFR_PIN_MAX, MFR_VOUT_MIN,
MFR_VOUT_MAX, MFR_IOUT_MAX, MFR_POUT_MAX, MFR_MAX_TEMP_1/2/3.

Tested with OpenBMC stack. All rated attributes were available
and reported correct values.

Signed-off-by: Zbigniew Lukwinski <zbigniew.lukwinski@linux.intel.com>
Link: https://lore.kernel.org/r/1596224237-32280-4-git-send-email-zbigniew.lukwinski@linux.intel.com
Signed-off-by: Guenter Roeck <linux@roeck-us.net>

3 files changed, 68 insertions, 9 deletions

diff --git a/Documentation/hwmon/pmbus.rst b/Documentation/hwmon/pmbus.rst
index 66b3e894612f..67284bd5f4cd 100644
--- a/Documentation/hwmon/pmbus.rst
+++ b/Documentation/hwmon/pmbus.rst
@@ -211,6 +211,10 @@ inX_lcrit_alarm		Voltage critical low alarm.
 inX_crit_alarm		Voltage critical high alarm.
 			From VOLTAGE_OV_FAULT status.
 inX_label		"vin", "vcap", or "voutY"
+inX_rated_min		Minimum rated voltage.
+			From MFR_VIN_MIN or MFR_VOUT_MIN register.
+inX_rated_max		Maximum rated voltage.
+			From MFR_VIN_MAX or MFR_VOUT_MAX register.
 
 currX_input		Measured current. From READ_IIN or READ_IOUT register.
 currX_max		Maximum current.
@@ -230,6 +234,8 @@ currX_crit_alarm	Current critical high alarm.
 currX_label		"iin", "iinY", "iinY.Z", "ioutY", or "ioutY.Z",
 			where Y reflects the page number and Z reflects the
 			phase.
+currX_rated_max		Maximum rated current.
+			From MFR_IIN_MAX or MFR_IOUT_MAX register.
 
 powerX_input		Measured power. From READ_PIN or READ_POUT register.
 powerX_cap		Output power cap. From POUT_MAX register.
@@ -244,10 +250,12 @@ powerX_crit_alarm	Output power critical high alarm.
 powerX_label		"pin", "pinY", "pinY.Z", "poutY", or "poutY.Z",
 			where Y reflects the page number and Z reflects the
 			phase.
+powerX_rated_max	Maximum rated power.
+			From MFR_PIN_MAX or MFR_POUT_MAX register.
 
 tempX_input		Measured temperature.
 			From READ_TEMPERATURE_X register.
-tempX_min		Mimimum temperature. From UT_WARN_LIMIT register.
+tempX_min		Minimum temperature. From UT_WARN_LIMIT register.
 tempX_max		Maximum temperature. From OT_WARN_LIMIT register.
 tempX_lcrit		Critical low temperature.
 			From UT_FAULT_LIMIT register.
@@ -265,4 +273,9 @@ tempX_lcrit_alarm	Chip temperature critical low alarm. Set by comparing
 tempX_crit_alarm	Chip temperature critical high alarm. Set by comparing
 			READ_TEMPERATURE_X with OT_FAULT_LIMIT if
 			TEMP_OT_FAULT status is set.
+tempX_rated_min		Minimum rated temperature.
+			From MFR_TAMBIENT_MIN register.
+tempX_rated_max		Maximum rated temperature.
+			From MFR_TAMBIENT_MAX, MFR_MAX_TEMP_1, MFR_MAX_TEMP_2 or
+			MFR_MAX_TEMP_3 register.
 ======================= ========================================================
diff --git a/drivers/hwmon/pmbus/pmbus.h b/drivers/hwmon/pmbus/pmbus.h
index 18e06fc6c53f..6d9f2cf70bff 100644
--- a/drivers/hwmon/pmbus/pmbus.h
+++ b/drivers/hwmon/pmbus/pmbus.h
@@ -119,9 +119,22 @@ enum pmbus_regs {
 	PMBUS_MFR_DATE			= 0x9D,
 	PMBUS_MFR_SERIAL		= 0x9E,
 
+	PMBUS_MFR_VIN_MIN		= 0xA0,
+	PMBUS_MFR_VIN_MAX		= 0xA1,
+	PMBUS_MFR_IIN_MAX		= 0xA2,
+	PMBUS_MFR_PIN_MAX		= 0xA3,
+	PMBUS_MFR_VOUT_MIN		= 0xA4,
+	PMBUS_MFR_VOUT_MAX		= 0xA5,
+	PMBUS_MFR_IOUT_MAX		= 0xA6,
+	PMBUS_MFR_POUT_MAX		= 0xA7,
+
 	PMBUS_IC_DEVICE_ID		= 0xAD,
 	PMBUS_IC_DEVICE_REV		= 0xAE,
 
+	PMBUS_MFR_MAX_TEMP_1		= 0xC0,
+	PMBUS_MFR_MAX_TEMP_2		= 0xC1,
+	PMBUS_MFR_MAX_TEMP_3		= 0xC2,
+
 /*
  * Virtual registers.
  * Useful to support attributes which are not supported by standard PMBus
diff --git a/drivers/hwmon/pmbus/pmbus_core.c b/drivers/hwmon/pmbus/pmbus_core.c
index 44535add3a4a..89ea7da1403f 100644
--- a/drivers/hwmon/pmbus/pmbus_core.c
+++ b/drivers/hwmon/pmbus/pmbus_core.c
@@ -1404,6 +1404,12 @@ static const struct pmbus_limit_attr vin_limit_attrs[] = {
 	}, {
 		.reg = PMBUS_VIRT_RESET_VIN_HISTORY,
 		.attr = "reset_history",
+	}, {
+		.reg = PMBUS_MFR_VIN_MIN,
+		.attr = "rated_min",
+	}, {
+		.reg = PMBUS_MFR_VIN_MAX,
+		.attr = "rated_max",
 	},
 };
 
@@ -1467,7 +1473,13 @@ static const struct pmbus_limit_attr vout_limit_attrs[] = {
 	}, {
 		.reg = PMBUS_VIRT_RESET_VOUT_HISTORY,
 		.attr = "reset_history",
-	}
+	}, {
+		.reg = PMBUS_MFR_VOUT_MIN,
+		.attr = "rated_min",
+	}, {
+		.reg = PMBUS_MFR_VOUT_MAX,
+		.attr = "rated_max",
+	},
 };
 
 static const struct pmbus_sensor_attr voltage_attributes[] = {
@@ -1537,7 +1549,10 @@ static const struct pmbus_limit_attr iin_limit_attrs[] = {
 	}, {
 		.reg = PMBUS_VIRT_RESET_IIN_HISTORY,
 		.attr = "reset_history",
-	}
+	}, {
+		.reg = PMBUS_MFR_IIN_MAX,
+		.attr = "rated_max",
+	},
 };
 
 static const struct pmbus_limit_attr iout_limit_attrs[] = {
@@ -1571,7 +1586,10 @@ static const struct pmbus_limit_attr iout_limit_attrs[] = {
 	}, {
 		.reg = PMBUS_VIRT_RESET_IOUT_HISTORY,
 		.attr = "reset_history",
-	}
+	}, {
+		.reg = PMBUS_MFR_IOUT_MAX,
+		.attr = "rated_max",
+	},
 };
 
 static const struct pmbus_sensor_attr current_attributes[] = {
@@ -1622,7 +1640,10 @@ static const struct pmbus_limit_attr pin_limit_attrs[] = {
 	}, {
 		.reg = PMBUS_VIRT_RESET_PIN_HISTORY,
 		.attr = "reset_history",
-	}
+	}, {
+		.reg = PMBUS_MFR_PIN_MAX,
+		.attr = "rated_max",
+	},
 };
 
 static const struct pmbus_limit_attr pout_limit_attrs[] = {
@@ -1656,7 +1677,10 @@ static const struct pmbus_limit_attr pout_limit_attrs[] = {
 	}, {
 		.reg = PMBUS_VIRT_RESET_POUT_HISTORY,
 		.attr = "reset_history",
-	}
+	}, {
+		.reg = PMBUS_MFR_POUT_MAX,
+		.attr = "rated_max",
+	},
 };
 
 static const struct pmbus_sensor_attr power_attributes[] = {
@@ -1720,7 +1744,10 @@ static const struct pmbus_limit_attr temp_limit_attrs[] = {
 	}, {
 		.reg = PMBUS_VIRT_RESET_TEMP_HISTORY,
 		.attr = "reset_history",
-	}
+	}, {
+		.reg = PMBUS_MFR_MAX_TEMP_1,
+		.attr = "rated_max",
+	},
 };
 
 static const struct pmbus_limit_attr temp_limit_attrs2[] = {
@@ -1758,7 +1785,10 @@ static const struct pmbus_limit_attr temp_limit_attrs2[] = {
 	}, {
 		.reg = PMBUS_VIRT_RESET_TEMP2_HISTORY,
 		.attr = "reset_history",
-	}
+	}, {
+		.reg = PMBUS_MFR_MAX_TEMP_2,
+		.attr = "rated_max",
+	},
 };
 
 static const struct pmbus_limit_attr temp_limit_attrs3[] = {
@@ -1784,7 +1814,10 @@ static const struct pmbus_limit_attr temp_limit_attrs3[] = {
 		.attr = "crit",
 		.alarm = "crit_alarm",
 		.sbit = PB_TEMP_OT_FAULT,
-	}
+	}, {
+		.reg = PMBUS_MFR_MAX_TEMP_3,
+		.attr = "rated_max",
+	},
 };
 
 static const struct pmbus_sensor_attr temp_attributes[] = {