diff options
| -rw-r--r-- | drivers/leds/leds-st1202.c | 10 |
1 files changed, 5 insertions, 5 deletions
diff --git a/drivers/leds/leds-st1202.c b/drivers/leds/leds-st1202.c index 3ddf2786a745..eb75c2d36d47 100644 --- a/drivers/leds/leds-st1202.c +++ b/drivers/leds/leds-st1202.c @@ -99,9 +99,9 @@ static int st1202_pwm_pattern_write(struct st1202_chip *chip, int led_num, value_h = (u8)(value >> 8); /* - * Datasheet: Register address low = 1Eh + 2*(xh) + 18h*(yh), - * where x is the channel number (led number) in hexadecimal (x = 00h .. 0Bh) - * and y is the pattern number in hexadecimal (y = 00h .. 07h) + * Datasheet: Register address low = 1Eh + 2*(xh) + 18h*(yh), + * where x is the channel number (led number) in hexadecimal (x = 00h .. 0Bh) + * and y is the pattern number in hexadecimal (y = 00h .. 07h) */ ret = st1202_write_reg(chip, (ST1202_PATTERN_PWM + (led_num * 2) + 0x18 * pattern), value_l); @@ -298,8 +298,8 @@ static int st1202_setup(struct st1202_chip *chip) guard(mutex)(&chip->lock); /* - * Once the supply voltage is applied, the LED1202 executes some internal checks, - * afterwords it stops the oscillator and puts the internal LDO in quiescent mode. + * Once the supply voltage is applied, the LED1202 executes some internal checks. + * Afterwards, it stops the oscillator and puts the internal LDO in quiescent mode. * To start the device, EN bit must be set inside the “Device Enable” register at * address 01h. As soon as EN is set, the LED1202 loads the adjustment parameters * from the internal non-volatile memory and performs an auto-calibration procedure |