diff options
Diffstat (limited to 'Documentation/admin-guide/sysctl/vm.rst')
| -rw-r--r-- | Documentation/admin-guide/sysctl/vm.rst | 29 |
1 files changed, 17 insertions, 12 deletions
diff --git a/Documentation/admin-guide/sysctl/vm.rst b/Documentation/admin-guide/sysctl/vm.rst index f455fa00c00f..586cd4b86428 100644 --- a/Documentation/admin-guide/sysctl/vm.rst +++ b/Documentation/admin-guide/sysctl/vm.rst @@ -146,7 +146,7 @@ This should be used on systems where stalls for minor page faults are an acceptable trade for large contiguous free memory. Set to 0 to prevent compaction from moving pages that are unevictable. Default value is 1. On CONFIG_PREEMPT_RT the default value is 0 in order to avoid a page fault, due -to compaction, which would block the task from becomming active until the fault +to compaction, which would block the task from becoming active until the fault is resolved. @@ -428,7 +428,7 @@ While most applications need less than a thousand maps, certain programs, particularly malloc debuggers, may consume lots of them, e.g., up to one or two maps per allocation. -The default value is 65536. +The default value is 65530. memory_failure_early_kill: @@ -873,12 +873,17 @@ file-backed pages is less than the high watermark in a zone. unprivileged_userfaultfd ======================== -This flag controls whether unprivileged users can use the userfaultfd -system calls. Set this to 1 to allow unprivileged users to use the -userfaultfd system calls, or set this to 0 to restrict userfaultfd to only -privileged users (with SYS_CAP_PTRACE capability). +This flag controls the mode in which unprivileged users can use the +userfaultfd system calls. Set this to 0 to restrict unprivileged users +to handle page faults in user mode only. In this case, users without +SYS_CAP_PTRACE must pass UFFD_USER_MODE_ONLY in order for userfaultfd to +succeed. Prohibiting use of userfaultfd for handling faults from kernel +mode may make certain vulnerabilities more difficult to exploit. -The default value is 1. +Set this to 1 to allow unprivileged users to use the userfaultfd system +calls without any restrictions. + +The default value is 0. user_reserve_kbytes @@ -978,11 +983,11 @@ that benefit from having their data cached, zone_reclaim_mode should be left disabled as the caching effect is likely to be more important than data locality. -zone_reclaim may be enabled if it's known that the workload is partitioned -such that each partition fits within a NUMA node and that accessing remote -memory would cause a measurable performance reduction. The page allocator -will then reclaim easily reusable pages (those page cache pages that are -currently not used) before allocating off node pages. +Consider enabling one or more zone_reclaim mode bits if it's known that the +workload is partitioned such that each partition fits within a NUMA node +and that accessing remote memory would cause a measurable performance +reduction. The page allocator will take additional actions before +allocating off node pages. Allowing zone reclaim to write out pages stops processes that are writing large amounts of data from dirtying pages on other nodes. Zone |