diff options
Diffstat (limited to 'Documentation/driver-api/media/csi2.rst')
| -rw-r--r-- | Documentation/driver-api/media/csi2.rst | 11 |
1 files changed, 6 insertions, 5 deletions
diff --git a/Documentation/driver-api/media/csi2.rst b/Documentation/driver-api/media/csi2.rst index e1b838014906..11c52b0be8b8 100644 --- a/Documentation/driver-api/media/csi2.rst +++ b/Documentation/driver-api/media/csi2.rst @@ -28,15 +28,14 @@ interface elements must be present on the sub-device represents the CSI-2 transmitter. The V4L2_CID_LINK_FREQ control is used to tell the receiver driver the -frequency (and not the symbol rate) of the link. The -V4L2_CID_PIXEL_RATE is may be used by the receiver to obtain the pixel -rate the transmitter uses. The -:c:type:`v4l2_subdev_video_ops`->s_stream() callback provides an +frequency (and not the symbol rate) of the link. The V4L2_CID_PIXEL_RATE +control may be used by the receiver to obtain the pixel rate the transmitter +uses. The :c:type:`v4l2_subdev_video_ops`->s_stream() callback provides an ability to start and stop the stream. The value of the V4L2_CID_PIXEL_RATE is calculated as follows:: - pixel_rate = link_freq * 2 * nr_of_lanes / bits_per_sample + pixel_rate = link_freq * 2 * nr_of_lanes * 16 / k / bits_per_sample where @@ -54,6 +53,8 @@ where - Two bits are transferred per clock cycle per lane. * - bits_per_sample - Number of bits per sample. + * - k + - 16 for D-PHY and 7 for C-PHY The transmitter drivers must, if possible, configure the CSI-2 transmitter to *LP-11 mode* whenever the transmitter is powered on but |