diff options
Diffstat (limited to 'drivers/gpu/drm/amd/include/atomfirmware.h')
| -rw-r--r-- | drivers/gpu/drm/amd/include/atomfirmware.h | 209 |
1 files changed, 187 insertions, 22 deletions
diff --git a/drivers/gpu/drm/amd/include/atomfirmware.h b/drivers/gpu/drm/amd/include/atomfirmware.h index ae8f6d299ed9..ff855cb21d3f 100644 --- a/drivers/gpu/drm/amd/include/atomfirmware.h +++ b/drivers/gpu/drm/amd/include/atomfirmware.h @@ -726,18 +726,20 @@ struct vram_usagebyfirmware_v2_1 *************************************************************************** */ -enum atom_object_record_type_id -{ - ATOM_I2C_RECORD_TYPE =1, - ATOM_HPD_INT_RECORD_TYPE =2, - ATOM_OBJECT_GPIO_CNTL_RECORD_TYPE =9, - ATOM_CONNECTOR_HPDPIN_LUT_RECORD_TYPE =16, - ATOM_CONNECTOR_AUXDDC_LUT_RECORD_TYPE =17, - ATOM_ENCODER_CAP_RECORD_TYPE=20, - ATOM_BRACKET_LAYOUT_RECORD_TYPE=21, - ATOM_CONNECTOR_FORCED_TMDS_CAP_RECORD_TYPE=22, - ATOM_DISP_CONNECTOR_CAPS_RECORD_TYPE=23, - ATOM_RECORD_END_TYPE =0xFF, +enum atom_object_record_type_id { + ATOM_I2C_RECORD_TYPE = 1, + ATOM_HPD_INT_RECORD_TYPE = 2, + ATOM_CONNECTOR_CAP_RECORD_TYPE = 3, + ATOM_CONNECTOR_SPEED_UPTO = 4, + ATOM_OBJECT_GPIO_CNTL_RECORD_TYPE = 9, + ATOM_CONNECTOR_HPDPIN_LUT_RECORD_TYPE = 16, + ATOM_CONNECTOR_AUXDDC_LUT_RECORD_TYPE = 17, + ATOM_ENCODER_CAP_RECORD_TYPE = 20, + ATOM_BRACKET_LAYOUT_RECORD_TYPE = 21, + ATOM_CONNECTOR_FORCED_TMDS_CAP_RECORD_TYPE = 22, + ATOM_DISP_CONNECTOR_CAPS_RECORD_TYPE = 23, + ATOM_BRACKET_LAYOUT_V2_RECORD_TYPE = 25, + ATOM_RECORD_END_TYPE = 0xFF, }; struct atom_common_record_header @@ -760,6 +762,19 @@ struct atom_hpd_int_record uint8_t plugin_pin_state; }; +struct atom_connector_caps_record { + struct atom_common_record_header + record_header; //record_type = ATOM_CONN_CAP_RECORD_TYPE + uint16_t connector_caps; //01b if internal display is checked; 10b if internal BL is checked; 0 of Not +}; + +struct atom_connector_speed_record { + struct atom_common_record_header + record_header; //record_type = ATOM_CONN_SPEED_UPTO + uint32_t connector_max_speed; // connector Max speed attribute, it sets 8100 in Mhz when DP connector @8.1Ghz. + uint16_t reserved; +}; + // Bit maps for ATOM_ENCODER_CAP_RECORD.usEncoderCap enum atom_encoder_caps_def { @@ -885,6 +900,21 @@ struct atom_bracket_layout_record uint8_t reserved; struct atom_connector_layout_info conn_info[1]; }; +struct atom_bracket_layout_record_v2 { + struct atom_common_record_header + record_header; //record_type = ATOM_BRACKET_LAYOUT_RECORD_TYPE + uint8_t bracketlen; //Bracket Length in mm + uint8_t bracketwidth; //Bracket Width in mm + uint8_t conn_num; //Connector numbering + uint8_t mini_type; //Mini Type (0 = Normal; 1 = Mini) + uint8_t reserved1; + uint8_t reserved2; +}; + +enum atom_connector_layout_info_mini_type_def { + MINI_TYPE_NORMAL = 0, + MINI_TYPE_MINI = 1, +}; enum atom_display_device_tag_def{ ATOM_DISPLAY_LCD1_SUPPORT = 0x0002, //an embedded display is either an LVDS or eDP signal type of display @@ -911,6 +941,19 @@ struct atom_display_object_path_v2 uint8_t reserved; }; +struct atom_display_object_path_v3 { + uint16_t display_objid; //Connector Object ID or Misc Object ID + uint16_t disp_recordoffset; + uint16_t encoderobjid; //first encoder closer to the connector, could be either an external or intenal encoder + uint16_t reserved1; //only on USBC case, otherwise always = 0 + uint16_t reserved2; //reserved and always = 0 + uint16_t reserved3; //reserved and always = 0 + //a supported device vector, each display path starts with this.the paths are enumerated in the way of priority, + //a path appears first + uint16_t device_tag; + uint16_t reserved4; //reserved and always = 0 +}; + struct display_object_info_table_v1_4 { struct atom_common_table_header table_header; @@ -920,6 +963,15 @@ struct display_object_info_table_v1_4 struct atom_display_object_path_v2 display_path[8]; //the real number of this included in the structure is calculated by using the (whole structure size - the header size- number_of_path)/size of atom_display_object_path }; +struct display_object_info_table_v1_5 { + struct atom_common_table_header table_header; + uint16_t supporteddevices; + uint8_t number_of_path; + uint8_t reserved; + // the real number of this included in the structure is calculated by using the + // (whole structure size - the header size- number_of_path)/size of atom_display_object_path + struct atom_display_object_path_v3 display_path[8]; +}; /* *************************************************************************** @@ -1080,17 +1132,73 @@ struct atom_dc_golden_table_v1 uint32_t reserved[23]; }; -enum dce_info_caps_def +enum dce_info_caps_def { + // only for VBIOS + DCE_INFO_CAPS_FORCE_DISPDEV_CONNECTED = 0x02, + // only for VBIOS + DCE_INFO_CAPS_DISABLE_DFP_DP_HBR2 = 0x04, + // only for VBIOS + DCE_INFO_CAPS_ENABLE_INTERLAC_TIMING = 0x08, + // only for VBIOS + DCE_INFO_CAPS_LTTPR_SUPPORT_ENABLE = 0x20, + DCE_INFO_CAPS_VBIOS_LTTPR_TRANSPARENT_ENABLE = 0x40, +}; + +struct atom_display_controller_info_v4_5 { - // only for VBIOS - DCE_INFO_CAPS_FORCE_DISPDEV_CONNECTED =0x02, - // only for VBIOS - DCE_INFO_CAPS_DISABLE_DFP_DP_HBR2 =0x04, - // only for VBIOS - DCE_INFO_CAPS_ENABLE_INTERLAC_TIMING =0x08, - // only for VBIOS - DCE_INFO_CAPS_LTTPR_SUPPORT_ENABLE =0x20, - DCE_INFO_CAPS_VBIOS_LTTPR_TRANSPARENT_ENABLE = 0x40, + struct atom_common_table_header table_header; + uint32_t display_caps; + uint32_t bootup_dispclk_10khz; + uint16_t dce_refclk_10khz; + uint16_t i2c_engine_refclk_10khz; + uint16_t dvi_ss_percentage; // in unit of 0.001% + uint16_t dvi_ss_rate_10hz; + uint16_t hdmi_ss_percentage; // in unit of 0.001% + uint16_t hdmi_ss_rate_10hz; + uint16_t dp_ss_percentage; // in unit of 0.001% + uint16_t dp_ss_rate_10hz; + uint8_t dvi_ss_mode; // enum of atom_spread_spectrum_mode + uint8_t hdmi_ss_mode; // enum of atom_spread_spectrum_mode + uint8_t dp_ss_mode; // enum of atom_spread_spectrum_mode + uint8_t ss_reserved; + // DFP hardcode mode number defined in StandardVESA_TimingTable when EDID is not available + uint8_t dfp_hardcode_mode_num; + // DFP hardcode mode refreshrate defined in StandardVESA_TimingTable when EDID is not available + uint8_t dfp_hardcode_refreshrate; + // VGA hardcode mode number defined in StandardVESA_TimingTable when EDID is not avablable + uint8_t vga_hardcode_mode_num; + // VGA hardcode mode number defined in StandardVESA_TimingTable when EDID is not avablable + uint8_t vga_hardcode_refreshrate; + uint16_t dpphy_refclk_10khz; + uint16_t hw_chip_id; + uint8_t dcnip_min_ver; + uint8_t dcnip_max_ver; + uint8_t max_disp_pipe_num; + uint8_t max_vbios_active_disp_pipe_num; + uint8_t max_ppll_num; + uint8_t max_disp_phy_num; + uint8_t max_aux_pairs; + uint8_t remotedisplayconfig; + uint32_t dispclk_pll_vco_freq; + uint32_t dp_ref_clk_freq; + // Worst case blackout duration for a memory clock frequency (p-state) change, units of 100s of ns (0.1 us) + uint32_t max_mclk_chg_lat; + // Worst case memory self refresh exit time, units of 100ns of ns (0.1us) + uint32_t max_sr_exit_lat; + // Worst case memory self refresh entry followed by immediate exit time, units of 100ns of ns (0.1us) + uint32_t max_sr_enter_exit_lat; + uint16_t dc_golden_table_offset; // point of struct of atom_dc_golden_table_vxx + uint16_t dc_golden_table_ver; + uint32_t aux_dphy_rx_control0_val; + uint32_t aux_dphy_tx_control_val; + uint32_t aux_dphy_rx_control1_val; + uint32_t dc_gpio_aux_ctrl_0_val; + uint32_t dc_gpio_aux_ctrl_1_val; + uint32_t dc_gpio_aux_ctrl_2_val; + uint32_t dc_gpio_aux_ctrl_3_val; + uint32_t dc_gpio_aux_ctrl_4_val; + uint32_t dc_gpio_aux_ctrl_5_val; + uint32_t reserved[26]; }; /* @@ -1806,6 +1914,63 @@ struct atom_smu_info_v3_3 { uint32_t reserved; }; +struct atom_smu_info_v3_5 +{ + struct atom_common_table_header table_header; + uint8_t smuip_min_ver; + uint8_t smuip_max_ver; + uint8_t waflclk_ss_mode; + uint8_t gpuclk_ss_mode; + uint16_t sclk_ss_percentage; + uint16_t sclk_ss_rate_10hz; + uint16_t gpuclk_ss_percentage; // in unit of 0.001% + uint16_t gpuclk_ss_rate_10hz; + uint32_t core_refclk_10khz; + uint32_t syspll0_1_vco_freq_10khz; + uint32_t syspll0_2_vco_freq_10khz; + uint8_t pcc_gpio_bit; // GPIO bit shift in SMU_GPIOPAD_A configured for PCC, =0xff means invalid + uint8_t pcc_gpio_polarity; // GPIO polarity for CTF + uint16_t smugoldenoffset; + uint32_t syspll0_0_vco_freq_10khz; + uint32_t bootup_smnclk_10khz; + uint32_t bootup_socclk_10khz; + uint32_t bootup_mp0clk_10khz; + uint32_t bootup_mp1clk_10khz; + uint32_t bootup_lclk_10khz; + uint32_t bootup_dcefclk_10khz; + uint32_t ctf_threshold_override_value; + uint32_t syspll3_0_vco_freq_10khz; + uint32_t syspll3_1_vco_freq_10khz; + uint32_t bootup_fclk_10khz; + uint32_t bootup_waflclk_10khz; + uint32_t smu_info_caps; + uint16_t waflclk_ss_percentage; // in unit of 0.001% + uint16_t smuinitoffset; + uint32_t bootup_dprefclk_10khz; + uint32_t bootup_usbclk_10khz; + uint32_t smb_slave_address; + uint32_t cg_fdo_ctrl0_val; + uint32_t cg_fdo_ctrl1_val; + uint32_t cg_fdo_ctrl2_val; + uint32_t gdfll_as_wait_ctrl_val; + uint32_t gdfll_as_step_ctrl_val; + uint32_t bootup_dtbclk_10khz; + uint32_t fclk_syspll_refclk_10khz; + uint32_t smusvi_svc0_val; + uint32_t smusvi_svc1_val; + uint32_t smusvi_svd0_val; + uint32_t smusvi_svd1_val; + uint32_t smusvi_svt0_val; + uint32_t smusvi_svt1_val; + uint32_t cg_tach_ctrl_val; + uint32_t cg_pump_ctrl1_val; + uint32_t cg_pump_tach_ctrl_val; + uint32_t thm_ctf_delay_val; + uint32_t thm_thermal_int_ctrl_val; + uint32_t thm_tmon_config_val; + uint32_t reserved[16]; +}; + struct atom_smu_info_v3_6 { struct atom_common_table_header table_header; |