summaryrefslogtreecommitdiff
path: root/drivers/net/arm/Kconfig
diff options
context:
space:
mode:
Diffstat (limited to 'drivers/net/arm/Kconfig')
-rw-r--r--drivers/net/arm/Kconfig46
1 files changed, 46 insertions, 0 deletions
diff --git a/drivers/net/arm/Kconfig b/drivers/net/arm/Kconfig
new file mode 100644
index 000000000000..470364deded0
--- /dev/null
+++ b/drivers/net/arm/Kconfig
@@ -0,0 +1,46 @@
+#
+# Acorn Network device configuration
+# These are for Acorn's Expansion card network interfaces
+#
+config ARM_AM79C961A
+ bool "ARM EBSA110 AM79C961A support"
+ depends on NET_ETHERNET && ARM && ARCH_EBSA110
+ select CRC32
+ help
+ If you wish to compile a kernel for the EBSA-110, then you should
+ always answer Y to this.
+
+config ARM_ETHER1
+ tristate "Acorn Ether1 support"
+ depends on NET_ETHERNET && ARM && ARCH_ACORN
+ help
+ If you have an Acorn system with one of these (AKA25) network cards,
+ you should say Y to this option if you wish to use it with Linux.
+
+config ARM_ETHER3
+ tristate "Acorn/ANT Ether3 support"
+ depends on NET_ETHERNET && ARM && ARCH_ACORN
+ help
+ If you have an Acorn system with one of these network cards, you
+ should say Y to this option if you wish to use it with Linux.
+
+config ARM_ETHERH
+ tristate "I-cubed EtherH/ANT EtherM support"
+ depends on NET_ETHERNET && ARM && ARCH_ACORN
+ select CRC32
+ help
+ If you have an Acorn system with one of these network cards, you
+ should say Y to this option if you wish to use it with Linux.
+
+config ARM_ETHER00
+ tristate "Altera Ether00 support"
+ depends on NET_ETHERNET && ARM && ARCH_CAMELOT
+ help
+ This is the driver for Altera's ether00 ethernet mac IP core. Say
+ Y here if you want to build support for this into the kernel. It
+ is also available as a module (say M here) that can be inserted/
+ removed from the kernel at the same time as the PLD is configured.
+ If this driver is running on an epxa10 development board then it
+ will generate a suitable hw address based on the board serial
+ number (MTD support is required for this). Otherwise you will
+ need to set a suitable hw address using ifconfig.