summaryrefslogtreecommitdiff
path: root/drivers/net/wireless/ath/ath5k/phy.c
diff options
context:
space:
mode:
Diffstat (limited to 'drivers/net/wireless/ath/ath5k/phy.c')
-rw-r--r--drivers/net/wireless/ath/ath5k/phy.c6
1 files changed, 3 insertions, 3 deletions
diff --git a/drivers/net/wireless/ath/ath5k/phy.c b/drivers/net/wireless/ath/ath5k/phy.c
index bbfdcd5e7cb1..72474c0ccaff 100644
--- a/drivers/net/wireless/ath/ath5k/phy.c
+++ b/drivers/net/wireless/ath/ath5k/phy.c
@@ -117,7 +117,7 @@ static unsigned int ath5k_hw_rfb_op(struct ath5k_hw *ah,
/*
* This code is used to optimize rf gain on different environments
- * (temprature mostly) based on feedback from a power detector.
+ * (temperature mostly) based on feedback from a power detector.
*
* It's only used on RF5111 and RF5112, later RF chips seem to have
* auto adjustment on hw -notice they have a much smaller BANK 7 and
@@ -2746,7 +2746,7 @@ ath5k_setup_channel_powertable(struct ath5k_hw *ah,
/* Fill curves in reverse order
* from lower power (max gain)
* to higher power. Use curve -> idx
- * backmaping we did on eeprom init */
+ * backmapping we did on eeprom init */
u8 idx = pdg_curve_to_idx[pdg];
/* Grab the needed curves by index */
@@ -2848,7 +2848,7 @@ ath5k_setup_channel_powertable(struct ath5k_hw *ah,
/* Now we have a set of curves for this
* channel on tmpL (x range is table_max - table_min
* and y values are tmpL[pdg][]) sorted in the same
- * order as EEPROM (because we've used the backmaping).
+ * order as EEPROM (because we've used the backmapping).
* So for RF5112 it's from higher power to lower power
* and for RF2413 it's from lower power to higher power.
* For RF5111 we only have one curve. */