diff options
Diffstat (limited to 'include/linux/phy.h')
| -rw-r--r-- | include/linux/phy.h | 60 |
1 files changed, 59 insertions, 1 deletions
diff --git a/include/linux/phy.h b/include/linux/phy.h index 563c46205685..5bc71d59910c 100644 --- a/include/linux/phy.h +++ b/include/linux/phy.h @@ -298,6 +298,29 @@ static inline const char *phy_modes(phy_interface_t interface) } } +/** + * rgmii_clock - map link speed to the clock rate + * @speed: link speed value + * + * Description: maps RGMII supported link speeds + * into the clock rates. + * + * Returns: clock rate or negative errno + */ +static inline long rgmii_clock(int speed) +{ + switch (speed) { + case SPEED_10: + return 2500000; + case SPEED_100: + return 25000000; + case SPEED_1000: + return 125000000; + default: + return -EINVAL; + } +} + #define PHY_INIT_TIMEOUT 100000 #define PHY_FORCE_TIMEOUT 10 @@ -818,6 +841,24 @@ struct phy_tdr_config { #define PHY_PAIR_ALL -1 /** + * enum link_inband_signalling - in-band signalling modes that are supported + * + * @LINK_INBAND_DISABLE: in-band signalling can be disabled + * @LINK_INBAND_ENABLE: in-band signalling can be enabled without bypass + * @LINK_INBAND_BYPASS: in-band signalling can be enabled with bypass + * + * The possible and required bits can only be used if the valid bit is set. + * If possible is clear, that means inband signalling can not be used. + * Required is only valid when possible is set, and means that inband + * signalling must be used. + */ +enum link_inband_signalling { + LINK_INBAND_DISABLE = BIT(0), + LINK_INBAND_ENABLE = BIT(1), + LINK_INBAND_BYPASS = BIT(2), +}; + +/** * struct phy_plca_cfg - Configuration of the PLCA (Physical Layer Collision * Avoidance) Reconciliation Sublayer. * @@ -957,6 +998,19 @@ struct phy_driver { int (*get_features)(struct phy_device *phydev); /** + * @inband_caps: query whether in-band is supported for the given PHY + * interface mode. Returns a bitmask of bits defined by enum + * link_inband_signalling. + */ + unsigned int (*inband_caps)(struct phy_device *phydev, + phy_interface_t interface); + + /** + * @config_inband: configure in-band mode for the PHY + */ + int (*config_inband)(struct phy_device *phydev, unsigned int modes); + + /** * @get_rate_matching: Get the supported type of rate matching for a * particular phy interface. This is used by phy consumers to determine * whether to advertise lower-speed modes for that interface. It is @@ -1818,6 +1872,9 @@ int phy_config_aneg(struct phy_device *phydev); int _phy_start_aneg(struct phy_device *phydev); int phy_start_aneg(struct phy_device *phydev); int phy_aneg_done(struct phy_device *phydev); +unsigned int phy_inband_caps(struct phy_device *phydev, + phy_interface_t interface); +int phy_config_inband(struct phy_device *phydev, unsigned int modes); int phy_speed_down(struct phy_device *phydev, bool sync); int phy_speed_up(struct phy_device *phydev); bool phy_check_valid(int speed, int duplex, unsigned long *features); @@ -1957,7 +2014,7 @@ int genphy_c45_plca_set_cfg(struct phy_device *phydev, int genphy_c45_plca_get_status(struct phy_device *phydev, struct phy_plca_status *plca_st); int genphy_c45_eee_is_active(struct phy_device *phydev, unsigned long *adv, - unsigned long *lp, bool *is_enabled); + unsigned long *lp); int genphy_c45_ethtool_get_eee(struct phy_device *phydev, struct ethtool_keee *data); int genphy_c45_ethtool_set_eee(struct phy_device *phydev, @@ -2014,6 +2071,7 @@ void phy_advertise_eee_all(struct phy_device *phydev); void phy_support_sym_pause(struct phy_device *phydev); void phy_support_asym_pause(struct phy_device *phydev); void phy_support_eee(struct phy_device *phydev); +void phy_disable_eee(struct phy_device *phydev); void phy_set_sym_pause(struct phy_device *phydev, bool rx, bool tx, bool autoneg); void phy_set_asym_pause(struct phy_device *phydev, bool rx, bool tx); |