diff options
Diffstat (limited to 'include/linux/spi')
| -rw-r--r-- | include/linux/spi/pxa2xx_spi.h | 56 | ||||
| -rw-r--r-- | include/linux/spi/rspi.h | 18 | ||||
| -rw-r--r-- | include/linux/spi/spi.h | 40 | ||||
| -rw-r--r-- | include/linux/spi/spi_bitbang.h | 7 | ||||
| -rw-r--r-- | include/linux/spi/xilinx_spi.h | 14 |
5 files changed, 35 insertions, 100 deletions
diff --git a/include/linux/spi/pxa2xx_spi.h b/include/linux/spi/pxa2xx_spi.h deleted file mode 100644 index ca2cd4e30ead..000000000000 --- a/include/linux/spi/pxa2xx_spi.h +++ /dev/null @@ -1,56 +0,0 @@ -/* SPDX-License-Identifier: GPL-2.0-or-later */ -/* - * Copyright (C) 2005 Stephen Street / StreetFire Sound Labs - */ -#ifndef __LINUX_SPI_PXA2XX_SPI_H -#define __LINUX_SPI_PXA2XX_SPI_H - -#include <linux/dmaengine.h> -#include <linux/types.h> - -#include <linux/pxa2xx_ssp.h> - -struct dma_chan; - -/* - * The platform data for SSP controller devices - * (resides in device.platform_data). - */ -struct pxa2xx_spi_controller { - u16 num_chipselect; - u8 enable_dma; - u8 dma_burst_size; - bool is_target; - - /* DMA engine specific config */ - dma_filter_fn dma_filter; - void *tx_param; - void *rx_param; - - /* For non-PXA arches */ - struct ssp_device ssp; -}; - -/* - * The controller specific data for SPI target devices - * (resides in spi_board_info.controller_data), - * copied to spi_device.platform_data ... mostly for - * DMA tuning. - */ -struct pxa2xx_spi_chip { - u8 tx_threshold; - u8 tx_hi_threshold; - u8 rx_threshold; - u8 dma_burst_size; - u32 timeout; -}; - -#if defined(CONFIG_ARCH_PXA) || defined(CONFIG_ARCH_MMP) - -#include <linux/clk.h> - -extern void pxa2xx_set_spi_info(unsigned id, struct pxa2xx_spi_controller *info); - -#endif - -#endif /* __LINUX_SPI_PXA2XX_SPI_H */ diff --git a/include/linux/spi/rspi.h b/include/linux/spi/rspi.h deleted file mode 100644 index dbdfcc7a3db2..000000000000 --- a/include/linux/spi/rspi.h +++ /dev/null @@ -1,18 +0,0 @@ -/* SPDX-License-Identifier: GPL-2.0-only */ -/* - * Renesas SPI driver - * - * Copyright (C) 2012 Renesas Solutions Corp. - */ - -#ifndef __LINUX_SPI_RENESAS_SPI_H__ -#define __LINUX_SPI_RENESAS_SPI_H__ - -struct rspi_plat_data { - unsigned int dma_tx_id; - unsigned int dma_rx_id; - - u16 num_chipselect; -}; - -#endif diff --git a/include/linux/spi/spi.h b/include/linux/spi/spi.h index c459809efee4..e4f3f3d30a03 100644 --- a/include/linux/spi/spi.h +++ b/include/linux/spi/spi.h @@ -351,10 +351,8 @@ struct spi_driver { struct device_driver driver; }; -static inline struct spi_driver *to_spi_driver(struct device_driver *drv) -{ - return drv ? container_of(drv, struct spi_driver, driver) : NULL; -} +#define to_spi_driver(__drv) \ + ( __drv ? container_of_const(__drv, struct spi_driver, driver) : NULL ) extern int __spi_register_driver(struct module *owner, struct spi_driver *sdrv); @@ -447,12 +445,12 @@ extern struct spi_device *spi_new_ancillary_device(struct spi_device *spi, u8 ch * @cur_msg_need_completion: Flag used internally to opportunistically skip * the @cur_msg_completion. This flag is used to signal the context that * is running spi_finalize_current_message() that it needs to complete() - * @cur_msg_mapped: message has been mapped for DMA * @fallback: fallback to PIO if DMA transfer return failure with * SPI_TRANS_FAIL_NO_START. * @last_cs_mode_high: was (mode & SPI_CS_HIGH) true on the last call to set_cs. * @last_cs: the last chip_select that is recorded by set_cs, -1 on non chip * selected + * @last_cs_index_mask: bit mask the last chip selects that were used * @xfer_completion: used by core transfer_one_message() * @busy: message pump is busy * @running: message pump is running @@ -532,6 +530,9 @@ extern struct spi_device *spi_new_ancillary_device(struct spi_device *spi, u8 ch * @queue_empty: signal green light for opportunistically skipping the queue * for spi_sync transfers. * @must_async: disable all fast paths in the core + * @defer_optimize_message: set to true if controller cannot pre-optimize messages + * and needs to defer the optimization step until the message is actually + * being transferred * * Each SPI controller can communicate with one or more @spi_device * children. These make a small bus, sharing MOSI, MISO and SCK signals @@ -707,7 +708,6 @@ struct spi_controller { bool running; bool rt; bool auto_runtime_pm; - bool cur_msg_mapped; bool fallback; bool last_cs_mode_high; s8 last_cs[SPI_CS_CNT_MAX]; @@ -775,6 +775,7 @@ struct spi_controller { /* Flag for enabling opportunistic skipping of the queue in spi_sync */ bool queue_empty; bool must_async; + bool defer_optimize_message; }; static inline void *spi_controller_get_devdata(struct spi_controller *ctlr) @@ -955,8 +956,8 @@ struct spi_res { * struct spi_transfer - a read/write buffer pair * @tx_buf: data to be written (DMA-safe memory), or NULL * @rx_buf: data to be read (DMA-safe memory), or NULL - * @tx_dma: DMA address of tx_buf, if @spi_message.is_dma_mapped - * @rx_dma: DMA address of rx_buf, if @spi_message.is_dma_mapped + * @tx_dma: DMA address of tx_buf, currently not for client use + * @rx_dma: DMA address of rx_buf, currently not for client use * @tx_nbits: number of bits used for writing. If 0 the default * (SPI_NBITS_SINGLE) is used. * @rx_nbits: number of bits used for reading. If 0 the default @@ -980,6 +981,8 @@ struct spi_res { * transfer this transfer. Set to 0 if the SPI bus driver does * not support it. * @transfer_list: transfers are sequenced through @spi_message.transfers + * @tx_sg_mapped: If true, the @tx_sg is mapped for DMA + * @rx_sg_mapped: If true, the @rx_sg is mapped for DMA * @tx_sg: Scatterlist for transmit, currently not for client use * @rx_sg: Scatterlist for receive, currently not for client use * @ptp_sts_word_pre: The word (subject to bits_per_word semantics) offset @@ -1066,8 +1069,7 @@ struct spi_transfer { /* * It's okay if tx_buf == rx_buf (right?). * For MicroWire, one buffer must be NULL. - * Buffers must work with dma_*map_single() calls, unless - * spi_message.is_dma_mapped reports a pre-existing mapping. + * Buffers must work with dma_*map_single() calls. */ const void *tx_buf; void *rx_buf; @@ -1077,20 +1079,24 @@ struct spi_transfer { #define SPI_TRANS_FAIL_IO BIT(1) u16 error; - dma_addr_t tx_dma; - dma_addr_t rx_dma; + bool tx_sg_mapped; + bool rx_sg_mapped; + struct sg_table tx_sg; struct sg_table rx_sg; + dma_addr_t tx_dma; + dma_addr_t rx_dma; unsigned dummy_data:1; unsigned cs_off:1; unsigned cs_change:1; - unsigned tx_nbits:3; - unsigned rx_nbits:3; + unsigned tx_nbits:4; + unsigned rx_nbits:4; unsigned timestamped:1; #define SPI_NBITS_SINGLE 0x01 /* 1-bit transfer */ #define SPI_NBITS_DUAL 0x02 /* 2-bit transfer */ #define SPI_NBITS_QUAD 0x04 /* 4-bit transfer */ +#define SPI_NBITS_OCTAL 0x08 /* 8-bit transfer */ u8 bits_per_word; struct spi_delay delay; struct spi_delay cs_change_delay; @@ -1111,8 +1117,6 @@ struct spi_transfer { * struct spi_message - one multi-segment SPI transaction * @transfers: list of transfer segments in this transaction * @spi: SPI device to which the transaction is queued - * @is_dma_mapped: if true, the caller provided both DMA and CPU virtual - * addresses for each transfer buffer * @pre_optimized: peripheral driver pre-optimized the message * @optimized: the message is in the optimized state * @prepared: spi_prepare_message was called for the this message @@ -1146,8 +1150,6 @@ struct spi_message { struct spi_device *spi; - unsigned is_dma_mapped:1; - /* spi_optimize_message() was called for this message */ bool pre_optimized; /* __spi_optimize_message() was called for this message */ @@ -1272,6 +1274,8 @@ static inline void spi_message_free(struct spi_message *m) extern int spi_optimize_message(struct spi_device *spi, struct spi_message *msg); extern void spi_unoptimize_message(struct spi_message *msg); +extern int devm_spi_optimize_message(struct device *dev, struct spi_device *spi, + struct spi_message *msg); extern int spi_setup(struct spi_device *spi); extern int spi_async(struct spi_device *spi, struct spi_message *message); diff --git a/include/linux/spi/spi_bitbang.h b/include/linux/spi/spi_bitbang.h index b930eca2ef7b..d4cb83195f7a 100644 --- a/include/linux/spi/spi_bitbang.h +++ b/include/linux/spi/spi_bitbang.h @@ -4,6 +4,8 @@ #include <linux/workqueue.h> +typedef u32 (*spi_bb_txrx_word_fn)(struct spi_device *, unsigned int, u32, u8, unsigned int); + struct spi_bitbang { struct mutex lock; u8 busy; @@ -28,9 +30,8 @@ struct spi_bitbang { int (*txrx_bufs)(struct spi_device *spi, struct spi_transfer *t); /* txrx_word[SPI_MODE_*]() just looks like a shift register */ - u32 (*txrx_word[4])(struct spi_device *spi, - unsigned nsecs, - u32 word, u8 bits, unsigned flags); + spi_bb_txrx_word_fn txrx_word[SPI_MODE_X_MASK + 1]; + int (*set_line_direction)(struct spi_device *spi, bool output); }; diff --git a/include/linux/spi/xilinx_spi.h b/include/linux/spi/xilinx_spi.h index 3934ce789d87..1b8d984668b6 100644 --- a/include/linux/spi/xilinx_spi.h +++ b/include/linux/spi/xilinx_spi.h @@ -2,19 +2,23 @@ #ifndef __LINUX_SPI_XILINX_SPI_H #define __LINUX_SPI_XILINX_SPI_H +#include <linux/types.h> + +struct spi_board_info; + /** * struct xspi_platform_data - Platform data of the Xilinx SPI driver - * @num_chipselect: Number of chip select by the IP. - * @little_endian: If registers should be accessed little endian or not. - * @bits_per_word: Number of bits per word. * @devices: Devices to add when the driver is probed. * @num_devices: Number of devices in the devices array. + * @num_chipselect: Number of chip select by the IP. + * @bits_per_word: Number of bits per word. + * @force_irq: If set, forces QSPI transaction requirements. */ struct xspi_platform_data { - u16 num_chipselect; - u8 bits_per_word; struct spi_board_info *devices; u8 num_devices; + u8 num_chipselect; + u8 bits_per_word; bool force_irq; }; |