diff options
Diffstat (limited to 'include/linux/usb.h')
| -rw-r--r-- | include/linux/usb.h | 104 |
1 files changed, 50 insertions, 54 deletions
diff --git a/include/linux/usb.h b/include/linux/usb.h index 739f1fd1cc15..2e87035e9479 100644 --- a/include/linux/usb.h +++ b/include/linux/usb.h @@ -45,27 +45,14 @@ struct wusb_dev; struct ep_device; -/* For SS devices */ -/** - * struct usb_host_ss_ep_comp - Valid for SuperSpeed devices only - * @desc: endpoint companion descriptor, wMaxPacketSize in native byteorder - * @extra: descriptors following this endpoint companion descriptor - * @extralen: how many bytes of "extra" are valid - */ -struct usb_host_ss_ep_comp { - struct usb_ss_ep_comp_descriptor desc; - unsigned char *extra; /* Extra descriptors */ - int extralen; -}; - /** * struct usb_host_endpoint - host-side endpoint descriptor and queue * @desc: descriptor for this endpoint, wMaxPacketSize in native byteorder + * @ss_ep_comp: SuperSpeed companion descriptor for this endpoint * @urb_list: urbs queued to this endpoint; maintained by usbcore * @hcpriv: for use by HCD; typically holds hardware dma queue head (QH) * with one or more transfer descriptors (TDs) per urb * @ep_dev: ep_device for sysfs info - * @ss_ep_comp: companion descriptor information for this endpoint * @extra: descriptors following this endpoint in the configuration * @extralen: how many bytes of "extra" are valid * @enabled: URBs may be submitted to this endpoint @@ -74,11 +61,11 @@ struct usb_host_ss_ep_comp { * descriptor within an active interface in a given USB configuration. */ struct usb_host_endpoint { - struct usb_endpoint_descriptor desc; + struct usb_endpoint_descriptor desc; + struct usb_ss_ep_comp_descriptor ss_ep_comp; struct list_head urb_list; void *hcpriv; struct ep_device *ep_dev; /* For sysfs info */ - struct usb_host_ss_ep_comp *ss_ep_comp; /* For SS devices */ unsigned char *extra; /* Extra descriptors */ int extralen; @@ -197,8 +184,6 @@ struct usb_interface { struct work_struct reset_ws; /* for resets in atomic context */ }; #define to_usb_interface(d) container_of(d, struct usb_interface, dev) -#define interface_to_usbdev(intf) \ - container_of(intf->dev.parent, struct usb_device, dev) static inline void *usb_get_intfdata(struct usb_interface *intf) { @@ -425,7 +410,6 @@ struct usb_tt; * @connect_time: time device was first connected * @do_remote_wakeup: remote wakeup should be enabled * @reset_resume: needs reset instead of resume - * @autosuspend_disabled: autosuspend disabled by the user * @wusb_dev: if this is a Wireless USB device, link to the WUSB * specific data for the device. * @slot_id: Slot ID assigned by xHCI @@ -501,13 +485,17 @@ struct usb_device { unsigned do_remote_wakeup:1; unsigned reset_resume:1; - unsigned autosuspend_disabled:1; #endif struct wusb_dev *wusb_dev; int slot_id; }; #define to_usb_device(d) container_of(d, struct usb_device, dev) +static inline struct usb_device *interface_to_usbdev(struct usb_interface *intf) +{ + return to_usb_device(intf->dev.parent); +} + extern struct usb_device *usb_get_dev(struct usb_device *dev); extern void usb_put_dev(struct usb_device *dev); @@ -526,8 +514,8 @@ extern struct usb_device *usb_find_device(u16 vendor_id, u16 product_id); /* USB autosuspend and autoresume */ #ifdef CONFIG_USB_SUSPEND -extern int usb_enable_autosuspend(struct usb_device *udev); -extern int usb_disable_autosuspend(struct usb_device *udev); +extern void usb_enable_autosuspend(struct usb_device *udev); +extern void usb_disable_autosuspend(struct usb_device *udev); extern int usb_autopm_get_interface(struct usb_interface *intf); extern void usb_autopm_put_interface(struct usb_interface *intf); @@ -572,6 +560,16 @@ static inline void usb_mark_last_busy(struct usb_device *udev) /* for drivers using iso endpoints */ extern int usb_get_current_frame_number(struct usb_device *usb_dev); +/* Sets up a group of bulk endpoints to support multiple stream IDs. */ +extern int usb_alloc_streams(struct usb_interface *interface, + struct usb_host_endpoint **eps, unsigned int num_eps, + unsigned int num_streams, gfp_t mem_flags); + +/* Reverts a group of bulk endpoints back to not using stream IDs. */ +extern void usb_free_streams(struct usb_interface *interface, + struct usb_host_endpoint **eps, unsigned int num_eps, + gfp_t mem_flags); + /* used these for multi-interface device registration */ extern int usb_driver_claim_interface(struct usb_driver *driver, struct usb_interface *iface, void *priv); @@ -958,17 +956,25 @@ extern int usb_disabled(void); #define URB_ISO_ASAP 0x0002 /* iso-only, urb->start_frame * ignored */ #define URB_NO_TRANSFER_DMA_MAP 0x0004 /* urb->transfer_dma valid on submit */ -#define URB_NO_SETUP_DMA_MAP 0x0008 /* urb->setup_dma valid on submit */ #define URB_NO_FSBR 0x0020 /* UHCI-specific */ #define URB_ZERO_PACKET 0x0040 /* Finish bulk OUT with short packet */ #define URB_NO_INTERRUPT 0x0080 /* HINT: no non-error interrupt * needed */ #define URB_FREE_BUFFER 0x0100 /* Free transfer buffer with the URB */ +/* The following flags are used internally by usbcore and HCDs */ #define URB_DIR_IN 0x0200 /* Transfer from device to host */ #define URB_DIR_OUT 0 #define URB_DIR_MASK URB_DIR_IN +#define URB_DMA_MAP_SINGLE 0x00010000 /* Non-scatter-gather mapping */ +#define URB_DMA_MAP_PAGE 0x00020000 /* HCD-unsupported S-G */ +#define URB_DMA_MAP_SG 0x00040000 /* HCD-supported S-G */ +#define URB_MAP_LOCAL 0x00080000 /* HCD-local-memory mapping */ +#define URB_SETUP_MAP_SINGLE 0x00100000 /* Setup packet DMA mapped */ +#define URB_SETUP_MAP_LOCAL 0x00200000 /* HCD-local setup packet */ +#define URB_DMA_SG_COMBINED 0x00400000 /* S-G entries were combined */ + struct usb_iso_packet_descriptor { unsigned int offset; unsigned int length; /* expected length */ @@ -1045,12 +1051,8 @@ typedef void (*usb_complete_t)(struct urb *); * @setup_packet: Only used for control transfers, this points to eight bytes * of setup data. Control transfers always start by sending this data * to the device. Then transfer_buffer is read or written, if needed. - * @setup_dma: For control transfers with URB_NO_SETUP_DMA_MAP set, the - * device driver has provided this DMA address for the setup packet. - * The host controller driver should use this in preference to - * setup_packet, but the HCD may chose to ignore the address if it must - * copy the setup packet into internal structures. Therefore, setup_packet - * must always point to a valid buffer. + * @setup_dma: DMA pointer for the setup packet. The caller must not use + * this field; setup_packet must point to a valid buffer. * @start_frame: Returns the initial frame for isochronous transfers. * @number_of_packets: Lists the number of ISO transfer buffers. * @interval: Specifies the polling interval for interrupt or isochronous @@ -1082,13 +1084,14 @@ typedef void (*usb_complete_t)(struct urb *); * bounce buffer or talking to an IOMMU), * although they're cheap on commodity x86 and ppc hardware. * - * Alternatively, drivers may pass the URB_NO_xxx_DMA_MAP transfer flags, - * which tell the host controller driver that no such mapping is needed since + * Alternatively, drivers may pass the URB_NO_TRANSFER_DMA_MAP transfer flag, + * which tells the host controller driver that no such mapping is needed for + * the transfer_buffer since * the device driver is DMA-aware. For example, a device driver might * allocate a DMA buffer with usb_alloc_coherent() or call usb_buffer_map(). - * When these transfer flags are provided, host controller drivers will - * attempt to use the dma addresses found in the transfer_dma and/or - * setup_dma fields rather than determining a dma address themselves. + * When this transfer flag is provided, host controller drivers will + * attempt to use the dma address found in the transfer_dma + * field rather than determining a dma address themselves. * * Note that transfer_buffer must still be set if the controller * does not support DMA (as indicated by bus.uses_dma) and when talking @@ -1111,11 +1114,9 @@ typedef void (*usb_complete_t)(struct urb *); * should always terminate with a short packet, even if it means adding an * extra zero length packet. * - * Control URBs must provide a setup_packet. The setup_packet and - * transfer_buffer may each be mapped for DMA or not, independently of - * the other. The transfer_flags bits URB_NO_TRANSFER_DMA_MAP and - * URB_NO_SETUP_DMA_MAP indicate which buffers have already been mapped. - * URB_NO_SETUP_DMA_MAP is ignored for non-control URBs. + * Control URBs must provide a valid pointer in the setup_packet field. + * Unlike the transfer_buffer, the setup_packet may not be mapped for DMA + * beforehand. * * Interrupt URBs must provide an interval, saying how often (in milliseconds * or, for highspeed devices, 125 microsecond units) @@ -1189,11 +1190,12 @@ struct urb { struct usb_device *dev; /* (in) pointer to associated device */ struct usb_host_endpoint *ep; /* (internal) pointer to endpoint */ unsigned int pipe; /* (in) pipe information */ + unsigned int stream_id; /* (in) stream ID */ int status; /* (return) non-ISO status */ unsigned int transfer_flags; /* (in) URB_SHORT_NOT_OK | ...*/ void *transfer_buffer; /* (in) associated data buffer */ dma_addr_t transfer_dma; /* (in) dma addr for transfer_buffer */ - struct usb_sg_request *sg; /* (in) scatter gather buffer list */ + struct scatterlist *sg; /* (in) scatter gather buffer list */ int num_sgs; /* (in) number of entries in the sg list */ u32 transfer_buffer_length; /* (in) data buffer length */ u32 actual_length; /* (return) actual transfer length */ @@ -1371,18 +1373,6 @@ void *usb_alloc_coherent(struct usb_device *dev, size_t size, void usb_free_coherent(struct usb_device *dev, size_t size, void *addr, dma_addr_t dma); -/* Compatible macros while we switch over */ -static inline void *usb_buffer_alloc(struct usb_device *dev, size_t size, - gfp_t mem_flags, dma_addr_t *dma) -{ - return usb_alloc_coherent(dev, size, mem_flags, dma); -} -static inline void usb_buffer_free(struct usb_device *dev, size_t size, - void *addr, dma_addr_t dma) -{ - return usb_free_coherent(dev, size, addr, dma); -} - #if 0 struct urb *usb_buffer_map(struct urb *urb); void usb_buffer_dmasync(struct urb *urb); @@ -1467,8 +1457,6 @@ struct usb_sg_request { struct usb_device *dev; int pipe; - struct scatterlist *sg; - int nents; int entries; struct urb **urbs; @@ -1553,6 +1541,14 @@ static inline unsigned int __create_pipe(struct usb_device *dev, #define usb_rcvintpipe(dev,endpoint) \ ((PIPE_INTERRUPT << 30) | __create_pipe(dev, endpoint) | USB_DIR_IN) +static inline struct usb_host_endpoint * +usb_pipe_endpoint(struct usb_device *dev, unsigned int pipe) +{ + struct usb_host_endpoint **eps; + eps = usb_pipein(pipe) ? dev->ep_in : dev->ep_out; + return eps[usb_pipeendpoint(pipe)]; +} + /*-------------------------------------------------------------------------*/ static inline __u16 |