From e4c78e210daea17f82f12037005df225e22189b9 Mon Sep 17 00:00:00 2001 From: Mike Snitzer Date: Wed, 15 Jul 2015 11:40:24 -0400 Subject: dm thin: display 'needs_check' in status if it is set There is currently no way to see that the needs_check flag has been set in the metadata. Display 'needs_check' in the thin-pool status if it is set in the thinp metadata. Also, update thinp documentation. Signed-off-by: Mike Snitzer --- Documentation/device-mapper/thin-provisioning.txt | 9 ++++++++- 1 file changed, 8 insertions(+), 1 deletion(-) (limited to 'Documentation/device-mapper/thin-provisioning.txt') diff --git a/Documentation/device-mapper/thin-provisioning.txt b/Documentation/device-mapper/thin-provisioning.txt index 4f67578b2954..1699a55b7b70 100644 --- a/Documentation/device-mapper/thin-provisioning.txt +++ b/Documentation/device-mapper/thin-provisioning.txt @@ -296,7 +296,7 @@ ii) Status underlying device. When this is enabled when loading the table, it can get disabled if the underlying device doesn't support it. - ro|rw + ro|rw|out_of_data_space If the pool encounters certain types of device failures it will drop into a read-only metadata mode in which no changes to the pool metadata (like allocating new blocks) are permitted. @@ -314,6 +314,13 @@ ii) Status module parameter can be used to change this timeout -- it defaults to 60 seconds but may be disabled using a value of 0. + needs_check + A metadata operation has failed, resulting in the needs_check + flag being set in the metadata's superblock. The metadata + device must be deactivated and checked/repaired before the + thin-pool can be made fully operational again. '-' indicates + needs_check is not set. + iii) Messages create_thin -- cgit v1.2.3