From 2acd30b9f6032c6cbefc5e255c17ebbb0718e56a Mon Sep 17 00:00:00 2001 From: Pierre-Louis Bossart Date: Tue, 8 Sep 2020 21:45:15 +0800 Subject: ASoC/soundwire: bus: use property to set interrupt masks Add a slave-level property and program the SCP_INT1_MASK as desired by the codec driver. Since there is no DisCo property this has to be an implementation-specific firmware property or hard-coded in the driver. The only functionality change is that implementation-defined interrupts are no longer set for amplifiers - those interrupts are typically for jack detection or acoustic event detection/hotwording. Signed-off-by: Pierre-Louis Bossart Signed-off-by: Bard Liao Tested-by: Srinivas Kandagatla Reviewed-by: Kai Vehmanen Reviewed-by: Guennadi Liakhovetski Acked-by: Mark Brown Link: https://lore.kernel.org/r/20200908134521.6781-2-yung-chuan.liao@linux.intel.com Signed-off-by: Vinod Koul --- drivers/soundwire/bus.c | 12 ++++++------ 1 file changed, 6 insertions(+), 6 deletions(-) (limited to 'drivers/soundwire') diff --git a/drivers/soundwire/bus.c b/drivers/soundwire/bus.c index d808f0256ba0..9f4cc24ccea3 100644 --- a/drivers/soundwire/bus.c +++ b/drivers/soundwire/bus.c @@ -1184,13 +1184,13 @@ static int sdw_initialize_slave(struct sdw_slave *slave) return ret; /* - * Set bus clash, parity and SCP implementation - * defined interrupt mask - * TODO: Read implementation defined interrupt mask - * from Slave property + * Set SCP_INT1_MASK register, typically bus clash and + * implementation-defined interrupt mask. The Parity detection + * may not always be correct on startup so its use is + * device-dependent, it might e.g. only be enabled in + * steady-state after a couple of frames. */ - val = SDW_SCP_INT1_IMPL_DEF | SDW_SCP_INT1_BUS_CLASH | - SDW_SCP_INT1_PARITY; + val = slave->prop.scp_int1_mask; /* Enable SCP interrupts */ ret = sdw_update(slave, SDW_SCP_INTMASK1, val, val); -- cgit v1.2.3