diff options
Diffstat (limited to 'include/linux')
| -rw-r--r-- | include/linux/can.h | 25 | ||||
| -rw-r--r-- | include/linux/input/eeti_ts.h | 1 | ||||
| -rw-r--r-- | include/linux/mfd/ezx-pcap.h | 1 | ||||
| -rw-r--r-- | include/linux/sched.h | 8 | ||||
| -rw-r--r-- | include/linux/security.h | 2 |
5 files changed, 15 insertions, 22 deletions
diff --git a/include/linux/can.h b/include/linux/can.h index 018055efc034..e52958d7c2d1 100644 --- a/include/linux/can.h +++ b/include/linux/can.h @@ -74,20 +74,21 @@ struct can_frame { /* * defined bits for canfd_frame.flags * - * As the default for CAN FD should be to support the high data rate in the - * payload section of the frame (HDR) and to support up to 64 byte in the - * data section (EDL) the bits are only set in the non-default case. - * Btw. as long as there's no real implementation for CAN FD network driver - * these bits are only preliminary. + * The use of struct canfd_frame implies the Extended Data Length (EDL) bit to + * be set in the CAN frame bitstream on the wire. The EDL bit switch turns + * the CAN controllers bitstream processor into the CAN FD mode which creates + * two new options within the CAN FD frame specification: * - * RX: NOHDR/NOEDL - info about received CAN FD frame - * ESI - bit from originating CAN controller - * TX: NOHDR/NOEDL - control per-frame settings if supported by CAN controller - * ESI - bit is set by local CAN controller + * Bit Rate Switch - to indicate a second bitrate is/was used for the payload + * Error State Indicator - represents the error state of the transmitting node + * + * As the CANFD_ESI bit is internally generated by the transmitting CAN + * controller only the CANFD_BRS bit is relevant for real CAN controllers when + * building a CAN FD frame for transmission. Setting the CANFD_ESI bit can make + * sense for virtual CAN interfaces to test applications with echoed frames. */ -#define CANFD_NOHDR 0x01 /* frame without high data rate */ -#define CANFD_NOEDL 0x02 /* frame without extended data length */ -#define CANFD_ESI 0x04 /* error state indicator */ +#define CANFD_BRS 0x01 /* bit rate switch (second bitrate for payload data) */ +#define CANFD_ESI 0x02 /* error state indicator of the transmitting node */ /** * struct canfd_frame - CAN flexible data rate frame structure diff --git a/include/linux/input/eeti_ts.h b/include/linux/input/eeti_ts.h index f875b316249d..16625d799b6f 100644 --- a/include/linux/input/eeti_ts.h +++ b/include/linux/input/eeti_ts.h @@ -2,6 +2,7 @@ #define LINUX_INPUT_EETI_TS_H struct eeti_ts_platform_data { + int irq_gpio; unsigned int irq_active_high; }; diff --git a/include/linux/mfd/ezx-pcap.h b/include/linux/mfd/ezx-pcap.h index 40c372165f3e..32a1b5cfeba1 100644 --- a/include/linux/mfd/ezx-pcap.h +++ b/include/linux/mfd/ezx-pcap.h @@ -16,6 +16,7 @@ struct pcap_subdev { struct pcap_platform_data { unsigned int irq_base; unsigned int config; + int gpio; void (*init) (void *); /* board specific init */ int num_subdevs; struct pcap_subdev *subdevs; diff --git a/include/linux/sched.h b/include/linux/sched.h index c147e7024f11..b8c86648a2f9 100644 --- a/include/linux/sched.h +++ b/include/linux/sched.h @@ -334,14 +334,6 @@ static inline void lockup_detector_init(void) } #endif -#if defined(CONFIG_LOCKUP_DETECTOR) && defined(CONFIG_SUSPEND) -void lockup_detector_bootcpu_resume(void); -#else -static inline void lockup_detector_bootcpu_resume(void) -{ -} -#endif - #ifdef CONFIG_DETECT_HUNG_TASK extern unsigned int sysctl_hung_task_panic; extern unsigned long sysctl_hung_task_check_count; diff --git a/include/linux/security.h b/include/linux/security.h index 4e5a73cdbbef..3dea6a9d568f 100644 --- a/include/linux/security.h +++ b/include/linux/security.h @@ -1242,8 +1242,6 @@ static inline void security_free_mnt_opts(struct security_mnt_opts *opts) * Check that the @parent process has sufficient permission to trace the * current process before allowing the current process to present itself * to the @parent process for tracing. - * The parent process will still have to undergo the ptrace_access_check - * checks before it is allowed to trace this one. * @parent contains the task_struct structure for debugger process. * Return 0 if permission is granted. * @capget: |