|author||Linus Torvalds <firstname.lastname@example.org>||2005-04-16 15:20:36 -0700|
|committer||Linus Torvalds <email@example.com>||2005-04-16 15:20:36 -0700|
Initial git repository build. I'm not bothering with the full history, even though we have it. We can create a separate "historical" git archive of that later if we want to, and in the meantime it's about 3.2GB when imported into git - space that would just make the early git days unnecessarily complicated, when we don't have a lot of good infrastructure for it. Let it rip!
Diffstat (limited to 'Documentation/fb/sa1100fb.txt')
1 files changed, 39 insertions, 0 deletions
diff --git a/Documentation/fb/sa1100fb.txt b/Documentation/fb/sa1100fb.txt
new file mode 100644
@@ -0,0 +1,39 @@
+[This file is cloned from VesaFB/matroxfb]
+What is sa1100fb?
+This is a driver for a graphic framebuffer for the SA-1100 LCD
+For most common passive displays, giving the option
+on the kernel command line should be enough to configure the
+controller. The bits per pixel (bpp) value should be 4, 8, 12, or
+16. LCCR values are display-specific and should be computed as
+documented in the SA-1100 Developer's Manual, Section 11.7. Dual-panel
+displays are supported as long as the SDS bit is set in LCCR0; GPIO<9:2>
+are used for the lower panel.
+For active displays or displays requiring additional configuration
+(controlling backlights, powering on the LCD, etc.), the command line
+options may not be enough to configure the display. Adding sections to
+sa1100fb_disable_lcd_controller(), and sa1100fb_enable_lcd_controller()
+will probably be necessary.
+bpp:<value> Configure for <value> bits per pixel
+lccr0:<value> Configure LCD control register 0 (11.7.3)
+lccr1:<value> Configure LCD control register 1 (11.7.4)
+lccr2:<value> Configure LCD control register 2 (11.7.5)
+lccr3:<value> Configure LCD control register 3 (11.7.6)
+Mark Huang <firstname.lastname@example.org>