Merge git://git.kernel.org/pub/scm/linux/kernel/git/netdev/net

Cross-merge networking fixes after downstream PR (net-6.13-rc4).

No conflicts.

Adjacent changes:

drivers/net/ethernet/renesas/rswitch.h
  32fd46f5b69e ("net: renesas: rswitch: remove speed from gwca structure")
  922b4b955a03 ("net: renesas: rswitch: rework ts tags management")

Signed-off-by: Jakub Kicinski <kuba@kernel.org>

1 files changed, 26 insertions, 10 deletions

diff --git a/drivers/net/can/m_can/m_can.c b/drivers/net/can/m_can/m_can.c
index 533bcb77c9f9..97cd8bbf2e32 100644
--- a/drivers/net/can/m_can/m_can.c
+++ b/drivers/net/can/m_can/m_can.c
@@ -1220,20 +1220,32 @@ static void m_can_coalescing_update(struct m_can_classdev *cdev, u32 ir)
 static int m_can_interrupt_handler(struct m_can_classdev *cdev)
 {
 	struct net_device *dev = cdev->net;
-	u32 ir;
+	u32 ir = 0, ir_read;
 	int ret;
 
 	if (pm_runtime_suspended(cdev->dev))
 		return IRQ_NONE;
 
-	ir = m_can_read(cdev, M_CAN_IR);
+	/* The m_can controller signals its interrupt status as a level, but
+	 * depending in the integration the CPU may interpret the signal as
+	 * edge-triggered (for example with m_can_pci). For these
+	 * edge-triggered integrations, we must observe that IR is 0 at least
+	 * once to be sure that the next interrupt will generate an edge.
+	 */
+	while ((ir_read = m_can_read(cdev, M_CAN_IR)) != 0) {
+		ir |= ir_read;
+
+		/* ACK all irqs */
+		m_can_write(cdev, M_CAN_IR, ir);
+
+		if (!cdev->irq_edge_triggered)
+			break;
+	}
+
 	m_can_coalescing_update(cdev, ir);
 	if (!ir)
 		return IRQ_NONE;
 
-	/* ACK all irqs */
-	m_can_write(cdev, M_CAN_IR, ir);
-
 	if (cdev->ops->clear_interrupts)
 		cdev->ops->clear_interrupts(cdev);
 
@@ -1695,6 +1707,14 @@ static int m_can_dev_setup(struct m_can_classdev *cdev)
 		return -EINVAL;
 	}
 
+	/* Write the INIT bit, in case no hardware reset has happened before
+	 * the probe (for example, it was observed that the Intel Elkhart Lake
+	 * SoCs do not properly reset the CAN controllers on reboot)
+	 */
+	err = m_can_cccr_update_bits(cdev, CCCR_INIT, CCCR_INIT);
+	if (err)
+		return err;
+
 	if (!cdev->is_peripheral)
 		netif_napi_add(dev, &cdev->napi, m_can_poll);
 
@@ -1746,11 +1766,7 @@ static int m_can_dev_setup(struct m_can_classdev *cdev)
 		return -EINVAL;
 	}
 
-	/* Forcing standby mode should be redundant, as the chip should be in
-	 * standby after a reset. Write the INIT bit anyways, should the chip
-	 * be configured by previous stage.
-	 */
-	return m_can_cccr_update_bits(cdev, CCCR_INIT, CCCR_INIT);
+	return 0;
 }
 
 static void m_can_stop(struct net_device *dev)