Merge tag 'pci-v6.1-changes' of git://git.kernel.org/pub/scm/linux/kernel/git/helgaas/pci

Pull pci updates from Bjorn Helgaas:
 "Resource management:

   - Distribute spare resources to unconfigured hotplug bridges at
     boot-time (not just when hot-adding such a bridge), which makes
     hot-adding devices to docks work better.

   - Revert to a BAR assignment inherited from firmware only when the
     address is actually reachable via any upstream bridges, which fixes
     some cases where firmware doesn't configure all devices.

   - Add a sysfs interface to resize BARs so this can be done before
     assigning devices to a VM through VFIO.

  Power management:

   - Disable Precision Time Management for all devices on suspend to
     enable lower-power PM state. We previously did this just for Root
     Ports, which isn't enough because downstream devices can still
     generate PTM messages, which cause errors if it's disabled in the
     Root Port.

   - Save and restore the ASPM L1 PM Substates configuration for
     suspend/ resume. Previously this configuration was lost, so L1.x
     states likely stopped working after resume.

   - Check whether the L1 PM Substates Capability exists. If it didn't
     exist, we previously read junk and tried to configure L1 Substates
     based on that.

   - Fix the LTR_L1.2_THRESHOLD computation, which previously set a
     threshold for entering L1.2 that was too low in some cases.

   - Reduce the delay after transitions to or from D3cold by using
     usleep_range() rather than msleep(), which often slept for ~19ms
     instead of the 10ms normally required. The spec says 10ms is
     enough, but it's possible we could trip over devices that need a
     little more.

  Error handling:

   - Work around a BIOS bug that caused Intel Root Ports to advertise a
     Root Port Programmed I/O (RP PIO) log size of zero, which caused
     annoying warnings and prevented the kernel from dumping log
     registers for DPC errors.

  Qualcomm PCIe controller driver:

   - Add support for SC8280XP and SA8540P host controllers and SM8450
     endpoint controller.

   - Disable Master AXI clock on endpoint controllers to save power when
     link is idle or in L1.x.

   - Expose link state transition counts via debugfs to help debug
     issues with low-power states.

   - Add auto-loading module support.

  Synopsys DesignWare PCIe controller driver:

   - Remove a dependency on ZONE_DMA32 by allocating the MSI target page
     differently. There's more work to do related to eDMA controllers,
     so it's not completely settled"

* tag 'pci-v6.1-changes' of git://git.kernel.org/pub/scm/linux/kernel/git/helgaas/pci: (71 commits)
  PCI: qcom-ep: Check platform_get_resource_byname() return value
  PCI: qcom-ep: Add support for SM8450 SoC
  dt-bindings: PCI: qcom-ep: Add support for SM8450 SoC
  dt-bindings: PCI: qcom-ep: Define clocks per platform
  PCI: qcom-ep: Make PERST separation optional
  dt-bindings: PCI: qcom-ep: Make PERST separation optional
  PCI: qcom-ep: Disable Master AXI Clock when there is no PCIe traffic
  PCI: Expose PCIe Resizable BAR support via sysfs
  PCI/ASPM: Correct LTR_L1.2_THRESHOLD computation
  PCI/ASPM: Ignore L1 PM Substates if device lacks capability
  PCI/ASPM: Factor out L1 PM Substates configuration
  PCI: qcom-ep: Gate Master AXI clock to MHI bus during L1SS
  PCI: qcom-ep: Expose link transition counts via debugfs
  PCI: qcom-ep: Disable IRQs during driver remove
  PCI/ASPM: Save L1 PM Substates Capability for suspend/resume
  PCI/ASPM: Refactor L1 PM Substates Control Register programming
  PCI: qcom-ep: Make use of the cached dev pointer
  PCI: qcom-ep: Rely on the clocks supplied by devicetree
  PCI: qcom-ep: Add kernel-doc for qcom_pcie_ep structure
  phy: freescale: imx8m-pcie: Fix the wrong order of phy_init() and phy_power_on()
  ...

1 files changed, 55 insertions, 8 deletions

diff --git a/drivers/pci/pci.h b/drivers/pci/pci.h
index 785f31086313..b1ebb7ab8805 100644
--- a/drivers/pci/pci.h
+++ b/drivers/pci/pci.h
@@ -505,13 +505,17 @@ static inline int pci_iov_bus_range(struct pci_bus *bus)
 #endif /* CONFIG_PCI_IOV */
 
 #ifdef CONFIG_PCIE_PTM
+void pci_ptm_init(struct pci_dev *dev);
 void pci_save_ptm_state(struct pci_dev *dev);
 void pci_restore_ptm_state(struct pci_dev *dev);
-void pci_disable_ptm(struct pci_dev *dev);
+void pci_suspend_ptm(struct pci_dev *dev);
+void pci_resume_ptm(struct pci_dev *dev);
 #else
+static inline void pci_ptm_init(struct pci_dev *dev) { }
 static inline void pci_save_ptm_state(struct pci_dev *dev) { }
 static inline void pci_restore_ptm_state(struct pci_dev *dev) { }
-static inline void pci_disable_ptm(struct pci_dev *dev) { }
+static inline void pci_suspend_ptm(struct pci_dev *dev) { }
+static inline void pci_resume_ptm(struct pci_dev *dev) { }
 #endif
 
 unsigned long pci_cardbus_resource_alignment(struct resource *);
@@ -561,10 +565,14 @@ bool pcie_wait_for_link(struct pci_dev *pdev, bool active);
 void pcie_aspm_init_link_state(struct pci_dev *pdev);
 void pcie_aspm_exit_link_state(struct pci_dev *pdev);
 void pcie_aspm_powersave_config_link(struct pci_dev *pdev);
+void pci_save_aspm_l1ss_state(struct pci_dev *dev);
+void pci_restore_aspm_l1ss_state(struct pci_dev *dev);
 #else
 static inline void pcie_aspm_init_link_state(struct pci_dev *pdev) { }
 static inline void pcie_aspm_exit_link_state(struct pci_dev *pdev) { }
 static inline void pcie_aspm_powersave_config_link(struct pci_dev *pdev) { }
+static inline void pci_save_aspm_l1ss_state(struct pci_dev *dev) { }
+static inline void pci_restore_aspm_l1ss_state(struct pci_dev *dev) { }
 #endif
 
 #ifdef CONFIG_PCIE_ECRC
@@ -575,12 +583,6 @@ static inline void pcie_set_ecrc_checking(struct pci_dev *dev) { }
 static inline void pcie_ecrc_get_policy(char *str) { }
 #endif
 
-#ifdef CONFIG_PCIE_PTM
-void pci_ptm_init(struct pci_dev *dev);
-#else
-static inline void pci_ptm_init(struct pci_dev *dev) { }
-#endif
-
 struct pci_dev_reset_methods {
 	u16 vendor;
 	u16 device;
@@ -774,4 +776,49 @@ static inline pci_power_t mid_pci_get_power_state(struct pci_dev *pdev)
 }
 #endif
 
+/*
+ * Config Address for PCI Configuration Mechanism #1
+ *
+ * See PCI Local Bus Specification, Revision 3.0,
+ * Section 3.2.2.3.2, Figure 3-2, p. 50.
+ */
+
+#define PCI_CONF1_BUS_SHIFT	16 /* Bus number */
+#define PCI_CONF1_DEV_SHIFT	11 /* Device number */
+#define PCI_CONF1_FUNC_SHIFT	8  /* Function number */
+
+#define PCI_CONF1_BUS_MASK	0xff
+#define PCI_CONF1_DEV_MASK	0x1f
+#define PCI_CONF1_FUNC_MASK	0x7
+#define PCI_CONF1_REG_MASK	0xfc /* Limit aligned offset to a maximum of 256B */
+
+#define PCI_CONF1_ENABLE	BIT(31)
+#define PCI_CONF1_BUS(x)	(((x) & PCI_CONF1_BUS_MASK) << PCI_CONF1_BUS_SHIFT)
+#define PCI_CONF1_DEV(x)	(((x) & PCI_CONF1_DEV_MASK) << PCI_CONF1_DEV_SHIFT)
+#define PCI_CONF1_FUNC(x)	(((x) & PCI_CONF1_FUNC_MASK) << PCI_CONF1_FUNC_SHIFT)
+#define PCI_CONF1_REG(x)	((x) & PCI_CONF1_REG_MASK)
+
+#define PCI_CONF1_ADDRESS(bus, dev, func, reg) \
+	(PCI_CONF1_ENABLE | \
+	 PCI_CONF1_BUS(bus) | \
+	 PCI_CONF1_DEV(dev) | \
+	 PCI_CONF1_FUNC(func) | \
+	 PCI_CONF1_REG(reg))
+
+/*
+ * Extension of PCI Config Address for accessing extended PCIe registers
+ *
+ * No standardized specification, but used on lot of non-ECAM-compliant ARM SoCs
+ * or on AMD Barcelona and new CPUs. Reserved bits [27:24] of PCI Config Address
+ * are used for specifying additional 4 high bits of PCI Express register.
+ */
+
+#define PCI_CONF1_EXT_REG_SHIFT	16
+#define PCI_CONF1_EXT_REG_MASK	0xf00
+#define PCI_CONF1_EXT_REG(x)	(((x) & PCI_CONF1_EXT_REG_MASK) << PCI_CONF1_EXT_REG_SHIFT)
+
+#define PCI_CONF1_EXT_ADDRESS(bus, dev, func, reg) \
+	(PCI_CONF1_ADDRESS(bus, dev, func, reg) | \
+	 PCI_CONF1_EXT_REG(reg))
+
 #endif /* DRIVERS_PCI_H */