blob: 2cc974e56bd2d3f83737b7583a74d1a882b6d500 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
|
#! /bin/bash
# SPDX-License-Identifier: GPL-2.0
# Copyright (c) 2015 Red Hat, Inc. All Rights Reserved.
#
# FS QA Test No. 137
#
# XFS v5 supers carry an LSN in various on-disk structures to track when
# associated metadata was last written to disk. These metadata LSNs must always
# be behind the current LSN as dictated by the log to ensure log recovery
# correctness after a potential crash. This test uses xfs_db to intentionally
# put the current LSN behind metadata LSNs and verifies that the kernel and
# xfs_repair detect the problem.
#
. ./common/preamble
_begin_fstest auto metadata v2log
# Import common functions.
# real QA test starts here
# Modify as appropriate.
_supported_fs xfs
_require_scratch
_require_scratch_xfs_crc
_require_xfs_db_command "logformat"
_scratch_mkfs >> $seqres.full 2>&1 || _fail "mkfs failed"
# push the log cycle ahead so we have room to move it backwards later
_scratch_xfs_db -x -c "logformat -c 3" >> $seqres.full 2>&1
# do some work on the fs to update metadata LSNs
_scratch_mount
$FSSTRESS_PROG -d $SCRATCH_MNT -n 999 -p 4 -w >> $seqres.full 2>&1
_scratch_unmount
# Reformat to the current cycle and try to mount. This fails in most cases
# because the sb LSN is ahead of the current LSN. If it doesn't fail, push the
# cycle back further and try again.
_scratch_xfs_db -x -c "logformat" >> $seqres.full 2>&1
_try_scratch_mount >> $seqres.full 2>&1
if [ $? != 0 ]; then
echo mount failure detected
else
_scratch_unmount
_scratch_xfs_db -x -c "logformat -c 2" >> $seqres.full 2>&1
_try_scratch_mount >> $seqres.full 2>&1 || echo mount failure detected
fi
# verify that repair detects invalid LSNs as well
_scratch_xfs_repair -n >> $seqres.full 2>&1 || \
echo repair failure detected
# repair for real so the post-test check can verify repair fixed things up
_scratch_xfs_repair >> $seqres.full 2>&1
# success, all done
status=0
exit
|
